This class-bd mono low-frequency amplifier pumps out 2,500 watts. It can easily drive four 2-ohm DVC woofers without breaking a sweat or any array of woofers wired to create a 1-ohm amplifier load. Use two amps in Power-Sync mode for a whopping 5,000 watt power horse! 0* 0/180 Phase Switch * 1/0 AWG power/ground connectors * 24dB/octave crossover * Audiophile grade speaker connections * Blue L.E.D. Stealth Signal/Power Meters - monitors signal & voltage with simulated VU needle * Infrasonic filter * MasterSync - allows 1 amplifier to control an array of amplifiers * MOSFET output stage * MOSFET power supply * PowerSync - allows 2 amplifiers to be "strapped" together * RCA pass-thru Conformal coated crossover Kapton former with insulated leads Proprietary UV coated polyamide basket with integrated grille Rockford Fosgate. It's a full sentence. It means POWER! It means ATTITUDE! Since 1973, when founder Jim Fosgate put his name on the first real piece of high performance audio equipment built for the car, nothing has been the same. While the rest of the world was struggling with really bad fashions and shoes that were way too high, Jim Fosgate, working in his garage in Arizona, USA, figured out that an amplifier, and for that matter, a car audio system would have to be dramatically different than what people were listening to in their homes.This meant an amplifier that could run low impedance loads, which meant that it would have to run in stereo and mono simultaneously. These needs then dictated that the amplifier incorporate a MOSFET design, a small detail that was unknown in the world of audio at the time. Wrap all this technobabble into the single most important development of the Fosgate designs The PUNCH EQ. The consistent theme here is not just music or technology but the brilliant use of technology and circuit design to enjoy impactful and passionate music. A real passion for the experience
Get Price
Hifonics Brutus BRZ D-Class Mono Block 1 x 1000 @ 4 OHMS, 1 x 2000 @ 2 OHMS, 1 x 3000 @ 1 OHM
Get Price
Rockford Fosgate Digital Signal Processor with OEM Integration capability Front Dual 31 Band Graphic Equalizer, Rear Dual 28 Band Graphic Equalizer, Sub 10 Band Graphic Equalizer, Center 31 band Graphic Equalizer, Aux Input 31 Band Graphic Equalizer, F/R/Sub Electronic Cross Over HP/BD/LP/AP 12/24db per Ocatave, Time Delay All Channels, Individual Channel Level Control, Saveable/Loadable Files. All features are controlled via a Bluetooth capable device (not included). Compatible operating systems include Palm, Windows Mobile 5.0 and Windows PC. Visit www.RockfordFosgate.com 24 hours a day for technical support or call (800)669-9899 M-F 7 am to 5 pm MST.
Get Price
Class D Monoblock Subwoofer Amplifier *
High-Damping Class D Circuit with discrete control circuitry *
Differential-Balanced Input Topology: 1 pair of inputs *
On-board Crossover: Fully-variable (40 - 200 Hz), selectable-slope (12 or 24 dB per octave) LP *
Bass EQ: Single-band parametric with variable boost up to +15dB and Remote Bass Option *
Preamp Output: 2-channel (independent active filter, parallel with amplifier filter or pass through) *
Output Polarity Reversal: Switch permits instant output polarity reversal *
Infrasonic Filter: Fully-variable 24dB/octave from 15-60 Hz *
Dual mono speaker output connections: Accept up to 8 AWG wire *
+12V and Ground connections: Accept 4 AWG wire (required) *
Rated Power: 1000 W RMS @ 1.5 ohm - 4 ohm (11V-14.5V) *
THD at Rated Power: 95dB below rated power (A-weighted, 20 Hz - 20 kHz noise bandwidth) *
Frequency Response: 5 Hz - 200 Hz (+0, -1dB) *
Damping Factor: >500 @ 4 ohm / 50 Hz *
Input Range: Switchable from 200mV-2V RMS to 800mV-8V RMS *
Dimensions (L x W x H): 19.70 x 9.25 x 2.36 in; 500 x 235 x 60 mm
Get Price
Rockford Fosgate Power T1500-1BDCP 1500 watt mono amplifier
Get Price
DB DRIVE A3PRO3000 Okur Pro Audio Series 2-Channel Amplifier (3000W max; 1200W x 2 @ 2Ω; 600W x 2 @ 4Ω)
Get Price
DB DRIVE A3PRO2400 Okur Pro Audio Series 2-Channel Amplifier (2400W max; 800 x 2 @ 2Ω; 400 x 2 @ 4Ω)
Get Price
SQA-4100 is a four channel dually bridgeable amp and provides a continuous maximum of 150 Watts per channel from each of 4 channels into 2 Ohms. CDT SQA-4100 will also provide a continuous maximum of 300 Watts bridged from each of two pairs of channels inqato 4 Ohms
CDT amplifiers have evolved over decades to include those components and design features, which provide optimal performance and virtually eliminate problems. No money has been wasted, building-in features that make no difference to the performance or reliability. On the other hand every conceivable problem has been anticipated and protection to the degree it is feasible has been included in CDT amplifier. This represents a best of breed philosophy in the industry.
The CDT clean looking amplifier line adheres to the most stringent engineering principles to bring you an unparalleled listening experience in the automotive environment. We offer a very flexible multi use amplifier Guaranteed values and a detailed power specification of each model. Typical power values are approximately much higher than rated, a specific individual birth/test sheet is supplied with each amplifier.
SQA-4100 Mosfet Class AB amplifier have internal variable 24/db per octave high and low pass adjustable crossovers. Built-in subsonic filter. 5 way protections. 2 Ohm Stable circuits. Soft Start/mute circuit. Trimode output configuration. Daisy chain through output RCA. Input level controls. The amplifier utilize massive robust power supplies and amplification stages for the maximum installed flexibility, impact reliable performance.
Get Price
Mono Power Density Digital Amplifier, 1200 watts x 1 chan @ 2 ohms, Signal-to-Noise Ratio: 80dBA, Compact Efficient Design, CEA-2006 Compliant Amplifier
Get Price
The P850.2 will easily drive multiple subwoofer configurations including one 2-ohm DVC subwoofer, a pair of 4-ohm DVC subwoofers, or four 4-ohm SVC subwoofers.
Get Price
Top Search
Last Search
